Rockbox Technical Forums

Rockbox General => Rockbox General Discussion => Topic started by: arnouds on December 16, 2011, 04:31:55 PM

Title: Change in Rockbox util.?
Post by: arnouds on December 16, 2011, 04:31:55 PM

Hi! I have multiple Sansa disks clip+, all the same sandisk firmware (01.02.15) installed.
In the first 2 clips, I could perform the automatic install of Rockbox 3.91 using the RB util.
But, strangely enough, since the recent Rockbox 3.10, I can't get the auto install to succeed on my third clip+ (it says it has succeeded, but the player doesn't perform a firmware upgrade after deconnecting).
In the end, I succeeded to do a manual install.
But I wondered, did the RB utility change too with the arrival of RB 3.10?

Thanks,
Arnoud

Title: Re: Change in Rockbox util.?
Post by: saratoga on December 16, 2011, 05:04:14 PM

No, we didn't update rbutil recently.

Title: Re: Change in Rockbox util.?
Post by: bluebrother on December 16, 2011, 06:55:59 PM

Quote from: saratoga on December 16, 2011, 05:04:14 PM

No, we didn't update rbutil recently.

That's not entirely correct depending on the meaning of "recently" :) A new version of Rockbox Utility has been released a bit (around 6 weeks) ago, but that's independent of Rockbox releases. Either case, Rockbox Utility checks for new versions so in case you will get notified.

Quote from: arnouds on December 16, 2011, 04:31:55 PM

But I wondered, did the RB utility change too with the arrival of RB 3.10?

Everyone can also check this easily on the RockboxUtility wiki page (http://www.rockbox.org/wiki/RockboxUtility), so there is really no need to ask. The wiki also holds a list of important changes. Please check the documentation before asking, it is written for a reason.

Title: Re: Change in Rockbox util.?
Post by: arnouds on December 16, 2011, 07:16:12 PM

Ok, thanx for your reply (I heard you  ;) ) and for the firmware, it's great stuff!  :)