1
Hardware / Re: I need cowon d2 emulator, but the link is dead, can anyone send a file to me?
« Last post by saratoga on Today at 05:55:10 PM »Keep in mind it also doesn't emulate the actual D2, just simulates the screen size and buttons.
2
New Ports / Re: Fiio M3k
« Last post by cereal_killer on Today at 05:14:06 PM »I've got few measurements for digital filters and DAC power mode illustrations.
Test signal is local file generated in REW software. 4kHz square signal, 192k sample rate, PCM24.
I am curious what the interpretation of these graphs is.
3
Hardware / Re: I need cowon d2 emulator, but the link is dead, can anyone send a file to me?
« Last post by cereal_killer on Today at 05:09:01 PM »http://rasher.dk/rockbox/simulator/cowond2-sim-w32.zip works for me.
4
Rockbox General Discussion / Re: Recommended inexpensive hardware for audio capture?
« Last post by Ant1 on Today at 02:58:13 PM »I am also would like to hear about such devices.
Looking for something with mic jack and rockbox for wav recordings.
Some voice recorders available on the market uses some mp3 or other codecs, but not wav. It would be nice to have it for my hobby with pocket PC recordings.
Looking for something with mic jack and rockbox for wav recordings.
Some voice recorders available on the market uses some mp3 or other codecs, but not wav. It would be nice to have it for my hobby with pocket PC recordings.
5
Unsupported Builds / Re: SANSA ClipZip Clip+ Fuze+ FuzeV2 Multiboot Bootloader and Firmware
« Last post by eugenkss on Today at 03:31:20 AM »When you install via the Rockbox Utility, you can select to install also the bootloader.
For manual installation, there are instructions in the Rockbox Manual on how to install a bootloader
For manual installation, there are instructions in the Rockbox Manual on how to install a bootloader
6
Rockbox General Discussion / Re: Installing Rockbox using MacBook. What’s wrong?
« Last post by omprakash on June 07, 2023, 07:40:09 PM »I solved it by granting full disk access and developer access in mac m1
7
Unsupported Builds / Re: SANSA ClipZip Clip+ Fuze+ FuzeV2 Multiboot Bootloader and Firmware
« Last post by cj17 on June 07, 2023, 05:29:49 PM »@7o9 Thanks very much for your reply.
I didn't install a bootloader - I thought because that part was struck out in the instructions that it was no longer necessary and installing a Dev build somehow made it not necessary. I saw it said the bootloaders were available on the "mainsite" but there was no link and I didn't see them on the mainsite.
So do I need to install the bootloader on my Clip Zip first? And where are the bootloaders?
Thank you!
I didn't install a bootloader - I thought because that part was struck out in the instructions that it was no longer necessary and installing a Dev build somehow made it not necessary. I saw it said the bootloaders were available on the "mainsite" but there was no link and I didn't see them on the mainsite.
So do I need to install the bootloader on my Clip Zip first? And where are the bootloaders?
Thank you!
8
Theming and Appearance Customization / Re: New WYSIWYG Theme Editor and other utilities in one app!
« Last post by bluebrother on June 06, 2023, 01:23:40 PM »At some point Google changed those links., seems old links broke. It's still up, try here:
https://drive.google.com/drive/folders/1MG_GaE0_7r-LoVy57_O-0ZG68U_ARWXG
https://drive.google.com/drive/folders/1MG_GaE0_7r-LoVy57_O-0ZG68U_ARWXG
9
Theming and Appearance Customization / Re: New WYSIWYG Theme Editor and other utilities in one app!
« Last post by tobijampar on June 06, 2023, 01:05:51 PM »Where is the bug list for the Theme Editor? Only found one bug from 2010 and no feature requests in the tracker.While at it I also created an updated Windows binary. You can find it here: https://drive.google.com/drive/folders/0B8pPsvGJ3RdKfnhyTDAwTWstMlhNR3NDanZURHFzOEI4ZHhoQUJ5OXUzN1NDRlp0U0hZNzQ?usp=sharing
After getting back into building a theme I looked for the theme editor again.
Sadly your google drive link does not work any more.
Do you still have the binary, and if so would you re-upload it?
Many thanks
Tobi
10
Rockbox General Discussion / Recommended inexpensive hardware for audio capture?
« Last post by gordonmcdowell on June 06, 2023, 12:58:34 PM »As I posted here way back in 2012...
https://hardware.slashdot.org/story/12/10/01/060205/rockbox--refurbished-mp3-players--crowdsourced-audio-capture
...I still continue to use Sandisk Clip devices loaded with RockBox to capture audio. They clip onto people's collars, aren't TOO big, and have decent battery life. The native firmware was MUCH worse for recording audio, and frankly I only get by thanks to Rockbox.
Have been looking around for inexpensive alternatives and still not found decent alternative.
In 2018 bought some blue-coloured Ammoon Y9P3 (which seemed to have vanished into the memory hole, no evidence of them every having existed) which do NOT run Rockbox and have issues such as over-modulation. They don't appear to be supported by Rockbox. I bought them off eBay but they came from China.
Can anyone recommend the cheapest, smallest, audio recorder that can load Rockbox? At one point that was Sandisk, and I was lucky to get ~20 bulk.
Today Sandisk Clip are about $40 and not available in bulk.
I'm hoping to spend $5 - $10 each, and get like 30 ?
Given my repeated bad-bad-bad experience with EVERY cheap audio recorder running native firmware, I'm basically looking for the cheapest, smallest MODERN HARDWARE that can run Rockbox. Something that I can still order today, off eBay or Amazon or Alibaba or wherever.
Can't believe I'm still using these Sandisk Clips, but any new cheap hardware I ever bought does stuff like only-record when people are talking, or can't handle even slightly loud audio. I need to leave these running on people's collars for hours, get the full audio, and sync in a video editor. So stopping-and-starting and over-modulation are basically the 2 things I can't work around.
https://hardware.slashdot.org/story/12/10/01/060205/rockbox--refurbished-mp3-players--crowdsourced-audio-capture
...I still continue to use Sandisk Clip devices loaded with RockBox to capture audio. They clip onto people's collars, aren't TOO big, and have decent battery life. The native firmware was MUCH worse for recording audio, and frankly I only get by thanks to Rockbox.
Have been looking around for inexpensive alternatives and still not found decent alternative.
In 2018 bought some blue-coloured Ammoon Y9P3 (which seemed to have vanished into the memory hole, no evidence of them every having existed) which do NOT run Rockbox and have issues such as over-modulation. They don't appear to be supported by Rockbox. I bought them off eBay but they came from China.
Can anyone recommend the cheapest, smallest, audio recorder that can load Rockbox? At one point that was Sandisk, and I was lucky to get ~20 bulk.
Today Sandisk Clip are about $40 and not available in bulk.
I'm hoping to spend $5 - $10 each, and get like 30 ?
Given my repeated bad-bad-bad experience with EVERY cheap audio recorder running native firmware, I'm basically looking for the cheapest, smallest MODERN HARDWARE that can run Rockbox. Something that I can still order today, off eBay or Amazon or Alibaba or wherever.
Can't believe I'm still using these Sandisk Clips, but any new cheap hardware I ever bought does stuff like only-record when people are talking, or can't handle even slightly loud audio. I need to leave these running on people's collars for hours, get the full audio, and sync in a video editor. So stopping-and-starting and over-modulation are basically the 2 things I can't work around.