Rockbox Technical Forums

Installation / Removal => Manual Installation => Iriver - Installation/Removal/Flashing => Topic started by: ronald_nld on October 29, 2006, 11:11:02 AM

Title: Problems to go back to original H320 firmware
Post by: ronald_nld on October 29, 2006, 11:11:02 AM
I have installed successfully the bootloader en patched h320 firmware
I used the iRiver 128 european firmware, and the H300 20061024 daily build.
But when I want to return to the original firmware as discribed in the manual (push rec button and turn on) the screen shortly flash up and the device turned off.
What is the right way to restore the original firmware?
Title: Re: Back to original H320 firmware
Post by: Febs on October 29, 2006, 11:18:48 AM
Be sure you hold the record button until you see the iriver logo.  Also, make sure that your battery is charged.  Rockbox will run at battery levels where the original firmware won't.
Title: Re: Problems to go back to original H320 firmware
Post by: ronald_nld on October 29, 2006, 11:38:25 AM
The battery is full charged, but I discovered what I did wrong.
I have not only hold the rec button until I see the iRiver splash screen, but also the start/play button. Normally when it boots you can release it.

Thanks anyway