Rockbox.org home
Downloads
Release release
Dev builds dev builds
Extras extras
themes themes
Documentation
Manual manual
Wiki wiki
Device Status device status
Support
Forums forums
Mailing lists mailing lists
IRC IRC
Development
Bugs bugs
Patches patches
Dev Guide dev guide
Search



Donate

+  Rockbox Technical Forums
|-+  Support and General Use
| |-+  Plugins/Viewers
| | |-+  I'm sorry for being a newbie (MPEG-2 conversion question)
« previous next »
Pages: [1]

Author Topic: I'm sorry for being a newbie (MPEG-2 conversion question)  (Read 1404 times)

Offline floydwaltz

  • Member
  • *
  • Posts: 3
I'm sorry for being a newbie (MPEG-2 conversion question)
« on: April 14, 2007, 03:47:59 PM »
I've have Cinema Craft Encoder to encode into Mpeg-2 (with audio), but when I try to play back the file, I have no luck.  Does Rockbox only play back video files encoded with another encoder?  I would like to figure out how to use CCE with Rockbox although if I have to I'll reluctantly switch.
« Last Edit: April 15, 2007, 03:01:28 AM by Midgey34 »
Logged

Offline Llorean

  • Member
  • *
  • Posts: 12931
Re: I'm sorry for being a newbie
« Reply #1 on: April 14, 2007, 03:55:04 PM »
As long as you're making a file that meets the requirements described on the PluginMpegplayer wiki page it should be fine.
Logged

Offline floydwaltz

  • Member
  • *
  • Posts: 3
Re: I'm sorry for being a newbie
« Reply #2 on: April 14, 2007, 09:04:36 PM »
Oh I just forgot to run it through TMPGEnc to convert the video stream from M2V to MPG.  Sorry for my stupidity.  This is my first time using Rockbox video and I must say good job.  The picture quality is way nicer than that on the original h300 firmware  ;D
Logged
Pages: [1]
« previous next »
+  Rockbox Technical Forums
|-+  Support and General Use
| |-+  Plugins/Viewers
| | |-+  I'm sorry for being a newbie (MPEG-2 conversion question)