Installation / Removal > Sandisk - Installation/Removal

Sansapatcher doesn't recognize e250

<< < (4/4)

xoring:

--- Quote from: alinasept on September 29, 2007, 09:27:13 PM ---
--- Quote from: cpchan on May 18, 2007, 01:59:58 AM ---
--- Quote from: coarse.sand on May 18, 2007, 01:03:02 AM ---I had the same problem as those above where the Sansa wasn't being detected by the ./sansapatcher command, and it also happened to be in standard FAT. I've switched the filing system to FAT32 now and it hasn't resolved anything. When inputed as "sudo ./sansapatcher", this is what appeared:
--- End quote ---

coarse.sand, I see what you are trying to do now. The problem is that your system is set to auto-mount. You must unmount /dev/sda1 first and then run sansapatcher. If you still have problems, post the output of the command:

lsusb

Charles


--- End quote ---


how do you unmount? when i type that into command prompt it says its not recognized

--- End quote ---

try 'umount' instead of 'unmount'.

chrisjs169:
On Linux, umount /dev/sdX

GodEater:
umount /dev/sda1

Not the lack of "n" after the "u".

mememeandyou:
How do you do this for Windows XP???

I've been searching these forums for an hour and have not been able to figure out how to get Sansapatcher to see my e260.


Ron

mememeandyou:

--- Quote from: mememeandyou on October 04, 2007, 08:43:54 PM ---How do you do this for Windows XP???

I've been searching these forums for an hour and have not been able to figure out how to get Sansapatcher to see my e260.


Ron

--- End quote ---


Never mind.  I got everything back to normal.

I will not be installing anymore second hand firmware anymore that's for sure!!!!


Ron

Navigation

[0] Message Index

[*] Previous page