Installation / Removal > Iriver - Installation/Removal/Flashing

Out of the loop lately on h10

<< < (2/3) > >>

007quick:
You need a dual boot enabled bootloader and then you need to make a decrypted version of the original h10.mi4 only after that is done can you hold the left botton to go to OF.

007quick:
There is a link to a guide on my website here:   http://007quick.googlepages.com/home
Near the bottom!

Febs:
There is also a link to a guide in the navigation bar to the left.  It's called the "manual."

By the way, the link on your site does not link to the guide, but to page 6 of the thread that contains the guide.

007quick:
Ok, I think that I fixed the link so that it goes to the correct section of that forum. I have special settings so that I see it in the wrong order, so if someone could comfirm that it works would be great!  http://007quick.googlepages.com/home

dc4man:
It is possible to configure Rockbox to dual-boot, so that you can choose at start-up whether to run the original firmware or Rockbox. In order to dual-boot, you must first configure your player for dual-boot capability by following the directions on this wiki page: http://www.rockbox.org/twiki/bin/view/Main/H10InstallationBeta.

when i go there, nothing comes up but a messed up page w/out instructions. thats taking from the guide any ideas?

Navigation

[0] Message Index

[#] Next page

[*] Previous page