Support and General Use > Hardware

Not able to connect to PC since rockbox is on the Sansa E270

(1/5) > >>

tarant:
Help!  :'(  :'(  :'(

I have installed rockbox on my sansa e270. Since I restarted the mp3 player rockbox runs. But I can't connect to the pc (windows xp) now! (I tried it on two computers.) There is always an error message: "USB-Gerät wurde nicht erkannt". In english it is about "usb device could not be detected".  ???  ???  ???

what can I do now?

thanks

regards,
tarant

tarant:
In the http://download.rockbox.org/manual/rockbox-sansae200.pdf manual is written, that I can only delete the rockbox.e200 file to recover the old firmwire. Now I tried it to delete it with the file manager on the rockbox. At this moment it displays an error message after run up. "Loading Rockbox... Error! Can't load rockbox.e200."

This was really an expensive experiment with rockbox. Is there a possibilty to rescue my player? Or can I simply throw it away?

Bagder:
http://www.rockbox.org/twiki/bin/view/Main/SansaE200Unbrick

dan_a:
Rockbox does not support the USB port yet.  Assuming you followed the installation instructions, you should be able to boot up in the original firmware by holding |

tarant:

--- Quote from: dan_a on March 14, 2007, 02:37:39 PM ---Rockbox does not support the USB port yet.  Assuming you followed the installation instructions, you should be able to boot up in the original firmware by holding |

Navigation

[0] Message Index

[#] Next page