Support and General Use > Hardware

Sansa E200 weird line on top of screen.

(1/12) > >>

merwin:
The rockbox firmware doesn't seem to be initializing the display properly. I'm getting a line on top of the screen that seems to be 1 or 2 pixels high, and the entire width of the screen. It even will leave the line there when rockbox boots the OF.bin

ya.ph:
Ive had about the same problem once:

when loading the orginal firmware, vertical lines appeared from the top started to go down untill the bottom of the screen. The firmware never booted. Restarted the device by removing the battery (i didn't know then that it had a hardware shutdown fonction) and all was fine.

However I still see those lines on the top of the screen when i am booting the OF.

lavid:
Yeah, I reported this on IRC when they first got the BL working but I was the only one. Now that it's supported it seems I'm not the only one. It's definitely part of the BL since it stays when you're in OF

dan_a:
That's odd: I have never had that problem.

We need to work out what is different between the working machines and the ones that have this problem.

First of all, could someone who is seeing this post up a photograph of the screen so I can see what we are talking about?

I'll raise a proper bug report for this tonight and post the link in this thread.

merwin:
This is very odd... i took a screendump, and it took the dump without those 2 lines... however, it seems there are about 2 pixels cut off of the screen height at the top (look at the clock to tell).

The height of the screendump is fine, however.

[attachment deleted by admin, too old]

Navigation

[0] Message Index

[#] Next page