Rockbox Development > New Ports
Sandisk Sansa e200R
zajacattack:
Well, it says here (http://daniel.haxx.se/sansa/e200tool.html) that you can use e200tool to extract the R series BL from the memory. Can't we just reverse it and write it to the memory, or is it not possible since we don't know where the R series BL is stored (no hidden partition)?
elborak:
And how will writing it to DRAM store it to non-volatile memory?
You really are covering ground already covered.
GodEater:
--- Quote from: zajacattack on July 29, 2007, 02:03:09 PM ---Well, it says here (http://daniel.haxx.se/sansa/e200tool.html) that you can use e200tool to extract the R series BL from the memory. Can't we just reverse it and write it to the memory, or is it not possible since we don't know where the R series BL is stored (no hidden partition)?
--- End quote ---
zajacattack, you really seem not to have any clue about what's going on when you run this command - and I strongly suggest you stop filling this thread with pointless nonsense.
Bagder:
Well, of course we could theoretically download the vanilla BL into the R model's memory and attempt to run it there, but the chance that the vanilla BL would then be able to upgrade bootloader properly is veeeery slim I'd say.
Of course, if someone is willing to take a very long shot with a high risk of frying their hardware, so feel free to experiment!
zajacattack:
I'm sorry if I'm filling up the thread, but no one else is working on this, so I am trying to brainstorm ideas to help move the work along. Well, where is the R series BL permanently located? (Also, why would writing the vanilla BL to the memory fry the hardware? And, I wasn't sure if writing the vanilla BL to the memory would somehow put it in permanently, so I was just double-checking because I don't know how the vanilla BL operates.)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version