Support and General Use > Hardware

Gigabeat dock is not recognized by winxp

(1/5) > >>

mr.pi:
hello rockboxer

i own a gigabeat f40 and if i connect the device only with the usb cable - it works.
but if i connect the dock with an usb cable, power on the gigabeat and put them into the cradle - it doesn't work. do i need a dock driver? where can i get the driver?

thanks for support

the pi

rosco_pc:
Hi,

The dock is not supported yet.

Nate!:
rosco_pc said:

--- Quote ---The dock is not supported yet.
--- End quote ---

This is not entirely true.  The Gigabeat cradle has been supported since 20070212.

Mr.pi what build/bootloader are you using?  Do you have the AC adapter plugged into the cradle also?  I can't really help if it's something else other than updating the firmware and bootloader.

rosco_pc:
I stand corrected, did not know that  :P

But I just tried it out under Linux and although the GB is recognized it is not being automounted.
Mhh notice now that it is also not automounted anymore when connected with cable only (which used to work). So I'll try and find out what is going on will report back.

roolku:
The dock works fine here in three aspects:

1) charging
2) lineout
3) USB

For the latter two you need to use the switch on the right hand side to select.

I do not think you need a driver, but I might be wrong and still use the one that gigabeat room installed unknowingly.

Navigation

[0] Message Index

[#] Next page