Third Party > Repairing and Upgrading Rockbox Capable Players
Sansa E200 Bricked by Recovery Mode
travisty:
I ran the script in recovery mode and it looks like it wrote to the device.
e200tool v0.0.6-alpha (c) by MrH 2006, 2007
Searching for device 0781:0720 ... 9 8 7 6 5 4 3 2 1 0 not found!
Searching for device 0b70:0003 ... found!
Initializing USB stub (3460 bytes) ... done!
Writing 'BL_SD_boardSupportSD.rom' to address 0x10600000
Searching for device 6666:e200 ... 9 8 found!
Write at 0x1065fc38
Write done!
Running from address 0x10600000
Searching for device 6666:e200 ... found!
Execution started!
But at this point I have no idea what to do. The directions say to copy a file to the recovery 'disk'. I don't see that I have to option to copy a file anywhere.
Bagder:
--- Quote ---I ran the script in recovery mode
--- End quote ---
Recovery mode, really?
That implies a working BL so why work so hard to write it if it works?
--- Quote ---The directions say to copy a file to the recovery 'disk'.
--- End quote ---
What instructions say you "copy a file to the recovery disk" ? I bet it mentions the original mi4 if so. And if you are in recovery mode, you can copy it there.
--- Quote ---I don't see that I have to option to copy a file anywhere.
--- End quote ---
Recovery mode allows you to mount the sansa and shows a 16MB disk. That's where you can copy the mi4 file to.
travisty:
OK, I'm starting to understand the modes better. I guess I wasn't in recovery mode. I don't have access to the recovery mode then. It doesn't matter what button combination I press when I plug the player in. I get the same black screen and glowing blue dial.
Even after my last post I'm still getting this on 'lsusb'
Bus 002 Device 011: ID 0b70:0003 PortalPlayer, Inc.
Is there any hope for my case?
Bagder:
--- Quote ---Bus 002 Device 011: ID 0b70:0003 PortalPlayer, Inc.
Is there any hope for my case?
--- End quote ---
Yes, try the i2c rom recovery process, which I mentioned before and I linked to the page describing how its done.
travisty:
I ran the script with the hold key on and I held down the record key when I plugged in the usb. The Script wrote to the device as before but nothing happens after that. This where I'm confused. What should happen next?
Searching for device 0781:0720 ... 9 8 7 6 5 4 3 2 1 0 not found!
Searching for device 0b70:0003 ... found!
Initializing USB stub (3460 bytes) ... done!
Writing 'BL_SD_boardSupportSD.rom' to address 0x10600000
Searching for device 6666:e200 ... 9 8 found!
Write at 0x1065fc38
Write done!
Running from address 0x10600000
Searching for device 6666:e200 ... found!
Execution started!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version