Third Party > Repairing and Upgrading Rockbox Capable Players
Sansa E200 Bricked by Recovery Mode
avba0:
--- Quote from: Bagder on March 09, 2007, 04:32:03 PM ---And you really have a BL_SD_boardSupportSD.rom file there?
--- End quote ---
Yes, thats the file (I have also try some other names), and even if it is not exist, is there anything else that could help?
Bagder:
--- Quote from: Lue on March 10, 2007, 10:24:00 AM ---
--- Quote from: Febs on March 10, 2007, 09:30:11 AM ---You probably need to run it from a command prompt.
--- End quote ---
The same result.......may there is a bug in the actual version?
--- End quote ---
It still pops up a window that immediately disappears when you run e200tool from a command prompt? What else does it output?
And you have libusb installed as well?
Bagder:
--- Quote from: avba0 on March 10, 2007, 12:09:49 PM ---
--- Quote from: Bagder on March 09, 2007, 04:32:03 PM ---And you really have a BL_SD_boardSupportSD.rom file there?
--- End quote ---
Yes, thats the file (I have also try some other names), and even if it is not exist, is there anything else that could help?
--- End quote ---
Sure, invoke the same procedure but run e200tool with a debugger to figure out why you can't do this when many others have already successfully done it.
avba0:
--- Quote from: Bagder on March 10, 2007, 12:16:55 PM ---Sure, invoke the same procedure but run e200tool with a debugger to figure out why you can't do this when many others have already successfully done it.
--- End quote ---
I don't know programming and I really don't know how to use a debugger, specially when I use Linux.
Is there any chance to use "200tool write ..." to unbreak my Sansa?
If is it possible, then how do I use it; and if not, it seems that there is no escape from studying programming and how to debug... :'(
Bagder:
--- Quote from: avba0 on March 10, 2007, 12:44:24 PM ---Is there any chance to use "200tool write ..." to unbreak my Sansa?
--- End quote ---
Yes, I would say it is very likely that e200tool can restore your Sansa. Are you really having that BL file in the same directory that you invoke e200tool in? If so, is there a right issue with it? Again, many others have run this exact command so it is a bit strange that it doesn't work for you. Heck, even using strace on the command would tell why it fails to open/load the BL file.
As a matter of fact, I've also just written this "unbrick" instructions page:
http://www.rockbox.org/twiki/bin/view/Main/SansaE200Unbrick
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version