Third Party > Repairing and Upgrading Rockbox Capable Players
Sansa E200 Bricked by Recovery Mode
Eisbaer:
I've a big problem since today:
My Sansa e260 won't start any more. The animated boot screen appears and disappears again, then the scroll wheel turns blue and the display stays black and nothing happens any more.
It is possible to get into the recovery mode, but there is no effect when plugging in the usb cable - my computer doesn't recognize any usb-device.
I also tried to unbrick my Sansa in the manufacturer mode in Ubuntu. Here is the terminal log:
----part 1-----
ubuntu@ubuntu:~$ sudo ./e200tool recover BL_SD_boardSupportSD.rom
e200tool v0.2.3-alpha (c) by MrH 2006, 2007
Searching for device 0781:0720 ... found!
Initializing USB stub (4780 bytes) ... done!
Writing 'BL_SD_boardSupportSD.rom' to address 0x10600000
Searching for device 6666:e200 ... 9 8 7 6 5 4 3 2 1 0 not found!
----part 2-----
ubuntu@ubuntu:~$ sudo ./e200tool i2cprogram i2c-e260.bin
e200tool v0.2.3-alpha (c) by MrH 2006, 2007
Programming i2c rom (address=87) range 0x0000-0x2000 from 'i2c-e260.bin'
Searching for device 6666:e200 ... 9 8 7 6 5 4 3 2 1 0 not found!
-----part 3-----
ubuntu@ubuntu:~$ sudo ./e200tool init
e200tool v0.2.3-alpha (c) by MrH 2006, 2007
Searching for device 0781:0720 ... found!
Initializing USB stub (4780 bytes) ... done!
-------------------
Anyone has further ideas or can help me in any way?
Thanks in advance!
zajacattack:
A couple of things:
1) For part one, did you make sure you held record while that command executed? Have you tried doing it again?
2) As for the next parts, you have to run ./e200tool init BEFORE you run ./e200tool i2cprogram
Eisbaer:
--- Quote from: zajacattack on March 02, 2008, 03:20:00 PM ---A couple of things:
1) For part one, did you make sure you held record while that command executed? Have you tried doing it again?
2) As for the next parts, you have to run ./e200tool init BEFORE you run ./e200tool i2cprogram
--- End quote ---
1) yes I tried with and without pressing record- no difference (I tried several times)
2) when I use the init command first, ic2 doesn't find my Sansa anymore... :-(
zajacattack:
Have you tried programming the i2c rom WITHOUT running ./e200tool recover BL_SD_boardSupportSD.rom first?
Do you have a different USB port and/or computer that you could try using?
Eisbaer:
--- Quote from: zajacattack on March 02, 2008, 03:27:00 PM ---1) Have you tried programming the i2c rom WITHOUT running ./e200tool recover BL_SD_boardSupportSD.rom first?
2) Do you have a different USB port and/or computer that you could try using?
--- End quote ---
1) Yes, no change.
2) Yes, also no change :'(
Thanks for your efforts anyway!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version