Third Party > Repairing and Upgrading Rockbox Capable Players

Sansa E200 Bricked by Recovery Mode

<< < (40/46) > >>

ItzBACON:
Ok, ran it as sudo, got this:

ubuntu@ubuntu:~/Desktop$ sudo ./e200tool recover BL_SD_BOARDSUPPORTSD.ROM
e200tool v0.2.3-alpha (c) by MrH 2006, 2007
Searching for device 0781:0720 ... 9 8 7 6 5 4 3 2 1 0 not found!
Searching for device 0b70:0003 ... found!
Initializing USB stub (4780 bytes) ... done!
Writing 'BL_SD_BOARDSUPPORTSD.ROM' to address 0x10600000
Searching for device 6666:e200 ... 9 8 found!
Write at 0x10660198
Write done!
Running from address 0x10600000
Searching for device 6666:e200 ... found!
Execution started!
ubuntu@ubuntu:~/Desktop$

After it does that, I tried the i2cprogram again with the i2c-e280.bin file and got this:

ubuntu@ubuntu:~/Desktop$ ./e200tool i2cprogram i2c-e280.bin
e200tool v0.2.3-alpha (c) by MrH 2006, 2007
Programming i2c rom (address=87) range 0x0000-0x2000 from 'i2c-e280.bin'
Searching for device 6666:e200 ... found!
Failed to claim the interface (-1, Operation not permitted)
ubuntu@ubuntu:~/Desktop$

If I run it as sudo, I get:

ubuntu@ubuntu:~/Desktop$ sudo ./e200tool i2cprogram i2c-e280.bin
e200tool v0.2.3-alpha (c) by MrH 2006, 2007
Programming i2c rom (address=87) range 0x0000-0x2000 from 'i2c-e280.bin'
Searching for device 6666:e200 ... found!
Set ptr - error (-71, Protocol error)
ubuntu@ubuntu:~/Desktop$

What next?

Also, thanks in advance for your all the help.

ItzBACON:
Oh, reason I run the i2cprogram command after recover is because nothing happens. Still the same blank screen and blue wheel.

JdGordon:
what EXACTLY are you trying to do?

ItzBACON:
Trying to unbrick it.

JdGordon:
usually when someone makes a point to emphasize a word its important... the fact that the emphasised word was "exactly" I can understand that you may have been confused, so I'll try again...


what is the actual problem your having? saying its bricked isnt helpful.

Navigation

[0] Message Index

[#] Next page

[*] Previous page