Third Party > Repairing and Upgrading Rockbox Capable Players

Sansa E200 Bricked by Recovery Mode

<< < (29/46) > >>

Lue:
HI @ all.

theres just another stone in my way to a fixed sansa:


--- Code: ---sudo ./e200tool recover BL_SD_boardSupportSD.rom
e200tool v0.2.3-alpha (c) by MrH 2006, 2007
Searching for device 0781:0720 ... found!
Initializing USB stub (4780 bytes) ... done!
Writing 'BL_SD_boardSupportSD.rom' to address 0x10600000
Searching for device 6666:e200 ... 9 8 found!
Write at 0x1065fc38
Write done!
Running from address 0x10600000
Searching for device 6666:e200 ... found!
Execution started!

--- End code ---

But after this nothing happened and afterRebooting my sansa -> same result, blue wheel lite.

So I have to restore the i2c boot rom, or not?
I have a sansa e280 must be european version, but there is no i2c file dumped for my sansa. can I use another one?

Thank you,
Lue

Bagder:

--- Quote from: Lue on April 01, 2007, 11:46:05 AM ---So I have to restore the i2c boot rom, or not?

--- End quote ---

It might very well be so.


--- Quote ---I have a sansa e280 must be european version, but there is no i2c file dumped for my sansa. can I use another one?

--- End quote ---

We don't know.

Lue:
Thank you,

is there a big difference between the i2c file from the e260 to the e280?
If not may i could use the i2c file from the e260 eu version,or will this brick my sansa even more!?

Thank you,
Lue

Brambo:
Lue,

I recovered my sansa e270 US with the e280 US i2c file because mine isn't on the e200tool page... so I'm not 100% sure, but for me it worked, using a i2c file that differs from my sansa type...

IF, IF you wanna try to recover with other i2c rom file, I advise you to try the EU 260 version because you also have a EU version... but use at your own risk... good luck!

Lue:
OK ...so far so good..

I got into recovery mode direct after I use the command:  sudo ./e200tool revover xxx.rom

The Recovery mode looks like this:

--- Code: ---
*********
Welcome to Recovery Mode
********

USB cable connected
Enter USB2.0 MSD Mode
LUN0 locked
LUN0 unlocked
LUN0 locked
LUN0 unlocked
LUN0 locked
LUN0 unlocked

--- End code ---

when I copy the mi4 file into the device and i plug the sansa of there stands:

Safe to disconnect..

will recover....

But then there remains the blue wheel lite and a black screen....


Help!?

When I press the on button 20sec and try to get into recovery mode - no chance...

Help me please..

Lue

**Update**

When i do it like jdgordon on page 7 (..."So as soon as it starts copying the rom across disable the hold switch, then as soon as you get the sansa logo on the screen disconnect the usb cable.")

I can connect the sansa on my windows pc and I have the 16mb recovery mode partition.
When I copy the mi4 file in it and disconnect the sansa, the sansa says "write image error"

What can I do??

Help!


Update-nr2

May there is an option to install rockbox to  install the original firmware!?
I don't know what to do....

Navigation

[0] Message Index

[#] Next page

[*] Previous page