Support and General Use > User Interface and Voice

too fast Power-on

(1/1)

Farbrausch:
Is it possible to set the Power-on delay?
Everytime i hit the Power-switch, by mistake, it plays for 5 min. then shut off.
In the orig. Firmware, you need to push the button for a few seconds to Power on!
Please help!

[IDC]Dragon:
No, you can't set this, since it is handled by my bootloader. No configuration supported at that early time.

Jörg

LinusN:
We could do it in the application, so that it expects the ON key to be pushed for a certain (configurable) amount of time after boot, else it does a clean shutdown again. This will of course only be practical with flashed devices.

Tron:
I would appreciate that. I often accidentally switch on the unit while it is being carried around - having to push the on-button for, say, half a second would greatly reduce that risk.

Cheers,
Tron

Navigation

[0] Message Index