Installation / Removal > Apple - Installation/Removal

Changing Firmware?

<< < (2/2)

PHK Brasil:

--- Quote from: GodEater on January 02, 2007, 03:18:01 AM ---The rockbox bootloader always boots into Rockbox by default - but if you put the hold switch to "on" immediately after you power on, it should boot into the Apple firmware.

--- End quote ---

Hi,

If you put the HOLD switch to ON while booting, Rockbox boots with "all cleared" (reset all settings).

To boot Apple's firmware you need to press and hold MENU while booting. A message will appears on screen: "Loading original firmware".

Bye.

[EDIT] This information I wrote above is wrong, only works on the old bootloader. The new one was modified. Sorry.
♪

Febs:

--- Quote from: sinister on January 02, 2007, 08:03:52 PM ---Which switch>
--- End quote ---

The HOLD switch:

linuxstb:
If you upgrade to the latest bootloader, the hold switch boots to the Apple firmware.  To reset the settings, you need to turn the hold switch on after the bootloader starts, but before Rockbox starts.

Information is here:

http://www.rockbox.org/twiki/bin/view/Main/IpodInstallationBeta

sinister:
Thanks everyone.

PHK Brasil:

--- Quote from: linuxstb on January 02, 2007, 08:56:26 PM ---If you upgrade to the latest bootloader, the hold switch boots to the Apple firmware.  To reset the settings, you need to turn the hold switch on after the bootloader starts, but before Rockbox starts.
--- End quote ---
♪
;D Oh... I'm sorry. I'm using the older bootloader.

The information is here: http://www.rockbox.org/twiki/bin/view/Main/IpodFAQ#How_to_start_the_original_Apple
Thanks!
♪

Navigation

[0] Message Index

[*] Previous page