Support and General Use > Hardware
iriver h1x0 - RTC (real time clock) mod
Peter200lx:
Ok, so I finally got enough time to do some more testing getting it to work for me. I have the first chip, and I had gotten the time to work but not the alarm. Even with a correct build, the play button was doing the rapid press thing. Today I had and idea and set the alarm to a specific time and enabled the alarm, and then soldered on the wire to play. Now both the clock and alarm are working without the problem of the play button.
So I think it would be a good idea to make it a bit more plain that you not only need the correct build, but also have the alarm enabled before you hook up that last wire.
But altogether I now have an entirely working rockbox with both the Clock and Alarm. THANKS MUCH!
roolku:
--- Quote from: Peter200lx on January 21, 2007, 11:08:03 PM ---So I think it would be a good idea to make it a bit more plain that you not only need the correct build, but also have the alarm enabled before you hook up that last wire.
But altogether I now have an entirely working rockbox with both the Clock and Alarm. THANKS MUCH!
--- End quote ---
Good to hear another success story. :)
I'll amend the wiki when it's back up.
--- Quote from: pilot000 on January 16, 2007, 06:04:32 PM ---Where can I buy in Switzerland or Europe a DS3231S ?
--- End quote ---
--- Quote from: Bedlore on January 21, 2007, 09:19:37 PM ---Can someone suggest where I can get a few at reasonably costs or alternatively be prepared to sell and post a few to me directly please?
--- End quote ---
If you work for a university or a company that's somewhat electronics related you can probably get away with ordering free samples (I did). Otherwise maybe you can get in contact with Software_Samurai:
http://forums.rockbox.org/index.php?topic=7605.msg63600#msg63600
TaperChuck:
wiki?
pilot000:
I received 2 samples from maxim today for free (sent to switzerland). Now I have to wait until my new 2200mAh battery arrives. Then I will apply the mod to my player. Thanks in advance for the detailed illustrated instructions.
TaperChuck:
Once the chip is installed and the software recognizes it, how do you set the correct time and configure it?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version