Author Topic: JBR v1 6gb - Replace a dead ATA controller? (Read 1550 times)

dannyg1 · « **on:** November 19, 2006, 12:13:43 PM »

Dreaded red LED, HD register error and the batteries were externally charged, with no good effect. Solder connections are fine. Charging circuit functions normally. Will attempt to replace wiring harness that diagonals from top to bottom of player next but, if that doesn't work, is it possible to replace the ATA controller?

Thanks,
DG1

LinusN · « **Reply #1 on:** November 19, 2006, 03:30:57 PM »

There is no ATA controller, only a few buffers. The rest is done in the CPU. Are you sure it's not the hard drive?

Besides, it could still be the batteries. Have you tried a new set of batteries?

dannyg1 · « **Reply #2 on:** November 25, 2006, 11:00:33 PM »

I bought an external box to do the full set of tests on the drive and it tests fine. Bought new batteries and an external charger. Have gone over the thing with a fine tooth comb, made sure that the drive is correctly FAT32 and still nada. Next up is to re-solder all the ground points.After that, I'll leave it. Bought a newer ARJ in the meantime so things are less urgent, though the new one may have the headphone jack wired backwards.....

DG1

Author Topic: JBR v1 6gb - Replace a dead ATA controller? (Read 1550 times)

dannyg1

JBR v1 6gb - Replace a dead ATA controller?

LinusN

Re: JBR v1 6gb - Replace a dead ATA controller?

dannyg1

Re: JBR v1 6gb - Replace a dead ATA controller?