Support and General Use > Recording
iriver h320 - basic questions
Multiplex:
I don't know about 'normal' but my H320 screen is not readable without the backlight in Rockbox - can't speak for the stock firmware, I've never used it.
It is noce to be able to read the display on the H120 without the light - but not worth sacrificing Jewels in coulour ;-)
petur:
No, the display of the h3x0 isn't readable without backlight at all, only when shining a very bright lightsource on it you can see a very faint image. Which is why rockbox switches off the LCD too to save more battery.
red:
Thanks again everyone for your help.
So far, I'm loving the h320. It's been recording for over 7.5 hours and the battery still has some juice in it. Rockbox rules!
I have another question about the backlight. I have it set to turn off in 10 seconds, and I have my clipping light also set to turn off after 10 seconds. But whenever it clips (I'm making it clip sometimes as I'm testing it out), the backlight stays on for a good minute. I don't see any other settings that might be affecting this, so I'm back to reread the manual.
pabouk:
It is this parameter: General Settings > Display > Peak Meter > Clip Hold Time.
red:
Thanks pabouk for confirming how to alter the clip hold time. I've doublechecked, and all of my backlight settings are set for only 5 or 10 seconds.
But oddly, sometimes (and only sometimes) the backlight stays on for a minute, and a few times it stayed on indefinitely (I stopped my test recording, started it again, and the backlight functioned correctly again). Does anyone have any ideas why this is happening (if I want to record and be stealthy a constant backlight is not a good thing, not to mention a drain on the battery).
I'm going to try a different build.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version