Installation / Removal > Iriver - Installation/Removal/Flashing

H120: problem in installing RB (HELP!!!)

<< < (2/3) > >>

Febs:
When you formatted in Windows, did you use FAT32 or NTFS?  You should use FAT32.

There are issues with installing Rockbox on a small number of H120s, most of which were sold by outletmp3.com.  I think Linus is looking into this.

pabouk:
The hard drive content should not influence the appearance of the Rockbox boot loader messages. They should even appear when you dismount the drive from the player.

The new players referred to as H120D or H140D are known to have problems with Rockbox but I have never heard of problems with the boot loader. Please correct me if I am wrong.

Fagior, do you think that iriver replaced the whole player or the whole printed circuit board inside?

fagior:
The problem I had on my player was about the headphone out; I think is very probable iRiver assistance changed the whole mainboard rather doing a very difficult manual soldering!
Evidently on the new one there's something different that inhibits the RB boot loader.
I am thinking to ask directly to iRiver about.
Do you think is it a good idea?
Do you think will this problem never been resolved?
Thank you.

fagior:
So I assume anyone can help me :'(

Is it possible only me have this problem? I tried asking to iRiver but they didn't aswer ...

Please, might the forum Experts say to me a hope word?

Thank you!

stripwax:
Is it related to this?
http://www.rockbox.org/mail/archive/rockbox-dev-archive-2006-11/0069.shtml

Search for "OutletMP3".

Navigation

[0] Message Index

[#] Next page

[*] Previous page