Support and General Use > Hardware

iRiver H120 REPAIRS - Sockets + Battery

<< < (2/2)

Techy_Bloke:
well ive blown something up internally because this is not a software issue because the rest of the player works fine...

i remmeber whilst testing and i got the first of the buzzing the player froze and i had to reset it....

Techy_Bloke:
is it possible in anyway that the software might just be stopping any of the input / outputs from working ??

i wanna try and get it working for this saturday...

but i gotta find the tools to pull it apart and have a look or give it to someone who knows wat there doing..

ive loaded it up on the original firmware and it is very laggy and non responsive to commands...

the headfones in and the line out sound dead.. but when i plug headfones into the input i get a slight pop/crackle

although i am not geting any input signal dected on line in

The Radio still works with the headfones connected as the antenna  it finds the stations on scan just no sound..

Techy_Bloke:
i am going to need a Torx screwdriver bit * that is smaller than a pin head pretty much ive tried those mini screw drivers used on computers and they are like 4x too big and my smallest screw driver bit from a security set and my torx set are 2x too big

once i  can get the torx screws out im hopeing that where it is blown is going to be really close to the section/ lid of the player where im goin to open it otherwise its gonna be hard trying to find it...

Techy_Bloke:
Ok so  i found this...

http://www.pdainternalbattery.com/iriverinstall.html

and then



and



which is wat i need to buy...

Navigation

[0] Message Index

[*] Previous page