Support and General Use > Audio Playback, Database and Playlists

wavpack, very minimal wps

<< < (2/7) > >>

gaillard:
well the audio cuts out completely and then resumes about 2 seconds later as if it couldn't keep up with decoding, although thats not the case right?

gaillard:
ok looking at the audio thread screen while a wavpack song is playing the pcm bar stays at 16000 or so and just goes up and down up and down.  but the codec just steadily drops.  when it hits zero the pcm instantly goes to zero and then back up to where it was and the codec goes back to where it started and counts down again.  everytime the codec hits 0 i get the cutout like i am talking about.


hope this helps.

Llorean:
Try settings your anti-skip buffer to a little bit higher than it defaults to (just 10 seconds more should be enough). In your case, this is actually the proper solution.

It has to do with a bug for calculating how large the anti-skip should be based upon seconds.

gaillard:
i put it on 1 min and it still does it.  it made it through the first song of a cd and on the second it is doing often now, every 8 seconds or so the codec line plumets and then i get the pause and it bumps back up.

Llorean:
Do you have disk power off enabled or disabled? Also, how large does it say your compressed buffer is? It should never go from full to empty in 8 seconds time, since uncompressed audio can fit more than that in the buffer.

Navigation

[0] Message Index

[#] Next page

[*] Previous page