Rockbox Development > New Ports
SAMSUNG YH-920
pyro_maniac:
Maybe with your knowledgebase i would come to the same conclusion but i m a newbie and i still don't know enough to get it done alone.
What would you prefer to do? Or is this target not attractive anymore?
saratoga:
--- Quote from: pyro_maniac on January 21, 2009, 05:49:10 PM ---Maybe with your knowledgebase i would come to the same conclusion but i m a newbie and i still don't know enough to get it done alone.
--- End quote ---
Start reading up. If you're going to make this work, you'll have to understand how the existing PP code works, the MI4 firmware format, etc.
--- Quote from: pyro_maniac on January 21, 2009, 05:49:10 PM ---What would you prefer to do? Or is this target not attractive anymore?
--- End quote ---
Obviously since you're the one working on the port, it was never all that appealing to most other people. Fortunately, since you're the one working on the port, it doesn't matter what other people think is appealing. Just what you're interested in.
pyro_maniac:
--- Quote from: wolly-p on January 21, 2009, 03:47:16 PM ---Hmmm, and after changing the config file, the whole compilation and mi4-scrambling went smoothly, no other error messages, and the newly created mi4-file was accepted immediately by the player?
If you do not see anything on the display, I guess it will be nearly impossible to get anywhere soon. As a last resort, you might want to try another display type (although size and grey-scale should be correct from what we have seen so far).
Since the new build is not adapted to your hardware, it is not surprising that the reset button does not work.
Does anyone have further ideas?
--- End quote ---
There were some warnings only. I think they where in point changing the LCD. Is it useful to make some other tryings with that driver in?
wolly-p:
--- Quote from: pyro_maniac on January 22, 2009, 08:32:33 AM ---There were some warnings only. I think they where in point changing the LCD. Is it useful to make some other tryings with that driver in?
--- End quote ---
I'm not sure. Take a careful look at the compiler warnings, they might give further hints. Also, it might be worthwile studying the code of other PP-based mi4-players regarding the display drivers.
pyro_maniac:
I ve put my eyes on the bootloader again. Is there a known way to put the device into the manufacturing mode and to read out the bootloader?
I ve read it in the IRC at the moment and i am thinking of asking there. But first i ask here.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version