Rockbox General > Rockbox General Discussion

Rockbox on HiFi Walker H2

(1/9) > >>

psyscott:
I have tried to install Rockbox on the H2 and I am getting it to apparently boot into Rockbox but I can't boot back into the native firmware. When I do boot into Rockbox, the font size is barely large enough for me read WITH glasses, but I don't see any settings so I don't know how to change the font size of the display. Also, I'm not sure if I've installed it correctly because I'm not able to do a dual boot and boot into the original firmware. Any help would be appreciated.

dconrad:
When you boot it up, does it go directly into Rockbox within about 3 seconds, or does it show the brand logo first, then bring up a menu which you need to select Rockbox from?

Font size can be changed by going to Settings --> Theme Settings --> Font. The numbers before each font are the size, so bigger numbers means bigger font.

psyscott:
I can get into the settings as you described. When I selected Font, I got this error message:
Segmentation fault at 00479(something... can't read it)
address 0xc
rockbox.erosq(rb_back trace+0x44) [ox482c4]
Thank you for replying.

psyscott:
Tried it again and got the same error when I selected Font. I can barely read it even with reading glasses so I really need that font size changed.
Thanks.

psyscott:
As much as I know about error and versions when I try to select fonts

14

906

address
rockbox erosq (rb_back trace+0x44) [0x4862c41

rockbox-aigoerosq-20250610
EROSQ-v18-patched.upt
Device HIFI Walker H2
Also doing DLs and copies to card (formatted Fat32) on a Mac

Navigation

[0] Message Index

[#] Next page