Support and General Use > Recording

[feature request] LCD-Remote Reduce Ticking *DURING RECORDING* (was a quesiton)

<< < (6/6)

whatboutbob:
Hmm...interesting work-around.  I quit using the remote in situations where I need more than about 20dB gain from the iriver because of that damn tick.

I'm not sure that I'll make use of this functionality though.  I'm too much of a control freak to fly blind on levels.

...perhaps if remote lcd updates were limited to monitor only peak levels?  So you would still know where you're peaking (not just when you're clipping)...but get minimal ticking.  Of course I've no idea if this is possible. :)

Hrmm...but the max peak hold time is only 1 min...so maybe that won't work.  If it were maybe 5 mins then maybe it would.  Theoretically you then just get a quick tick at the loudest point of a recording, when you're least likely to hear it...but still have some idea how close to clipping you are...

Davide-NYC:
I'm closing this thread since the problem has been solved by Mmmm.

Navigation

[0] Message Index

[*] Previous page