Rockbox General > Rockbox General Discussion

problems when updating sansa Clip+ to Rockbox 3.15

<< < (2/3) > >>

Bilgus:
if the sd is inserted and the redirect file is on the root of the sd card it will try the .rockbox folder on the sd card first

new_kata:
Oh ok, but why does it say "No .rockbox directory" and "Installation incomplete" then? I thought it was because it couldn't find the install on the internal drive first and tried the sd card afterwards...

Bilgus:
No it tries the sd card first then tries the internal drive did you copy the whole .rockbox folder to the sd card?
you also need the file rockbox_main.clip+ containing a single / on the root of the sd card as well
finally in the debug menu (System>Debug (keep out)) once rockbox boots you should see the entry [Boot data]
select it and it should tell you the boot volume <0 or 1> and 'CRC ok'

new_kata:
sorry for the lack of reply, I didn't have much time to check last week. yes, .rockbox dir is there and rockbox_main.clip+ with single / char as well.

so in the Boot Data Menu I see:


--- Quote ---Boot Volume: <1>
Root:
/<0>

Bootdata RAW:
Length: 4
CRC: 1b9847cc
CRC: OK!
00: 01 00 00 00

--- End quote ---

so <1> is the SD card?

Bilgus:
no in the dev version <1> is the internal drive once the firmware is running it just swaps them
your device is running from the sd card according to that output

CRC: 1b9847cc
CRC: OK!
00: 01 00 00 00

the sd card was <1> at boot but its been set as <0> by the firmware

as for the error I'd try re-copying the rockbox folder directly from the zip on to the SD card again

Navigation

[0] Message Index

[#] Next page

[*] Previous page