Rockbox General > Rockbox General Discussion

Sandisk Sansa clip + V1

<< < (2/3) > >>

Lacres:
Thank you. While installing Rockbox with the Rockbox utility, the program does not accept the OF 01.02.18. There was always a error message with some notes the player uses v1. Finally I installed Rockbox with the 01.02.16 firmware.  In addition to that the battery does not last very long. That is the reason why I thought the player could use the v1 processor.

Bilgus:
is the dpad round or square on your device?

Lacres:
Square, it is a clip plus.

saratoga:

--- Quote from: Lacres on November 23, 2019, 10:07:28 AM ---While installing Rockbox with the Rockbox utility, the program does not accept the OF 01.02.18. There was always a error message with some notes the player uses v1. Finally I installed Rockbox with the 01.02.16 firmware.  In addition to that the battery does not last very long. That is the reason why I thought the player could use the v1 processor.

--- End quote ---

That means you selected Clip V1 when installing the first time. Since you have a CLip+, the install failed and the installer pointed out that you had your devices mixed up.  Then you selected the right device the second time and it worked.

Lacres:
I have several Sansa clip+ but this was the first time rockbox utility does not accept the firmware 01.02.18. I tried it several times - there was always an error. Than I tried Rockbox Utility 3.14, the same problems. I always chose clip+ but an error reports a v1 mistake when the OF was required. At least I used 01.02.16 that works. Very strange because I never had this problem before although I used Rockbox utility very often?!

Navigation

[0] Message Index

[#] Next page

[*] Previous page