Rockbox Development > New Ports

Fiio M3k

<< < (80/80)

Hi guys. Any news about this?
Has discussion moved to a different thread?

There is a key remap plugin that might do what you want:

Hi all,

in a different thread (,54417.msg251622.html#msg251622) I was asking how to lower charging settings for my Sansa Clip+ and I'm wondering if it's possible to do the same with Fiio M3k.

In "/rockbox/firmware/target/mips/ingenic_x1000/fiiom3k/power-fiiom3k.c" there's a setting "axp_set_charge_current(780)" that should limit current @ 780 mA (o in my case I'd lower to 300-400 mA).

I'm not sure how to change charging voltage and I prefer to ask Aidan and other expert about this.

For what I know (I'm not an expert at all) limiting voltage @4.1 V would extend quite a lot battery life with only a small decrease in total battery capacity.



[0] Message Index

[*] Previous page

Go to full version