Installation / Removal > Sandisk - Installation/Removal

ISSUE W/ 3.14 VERIFIED: Can't install on Fuze V2 (ATA error -2)

<< < (2/3) > >>

I can probably give you a test build (I believe this same issue was reported and resolved in a previous thread), but I'm traveling this week and cannot compile it.

Try this build:

It raises the voltage used on the CPU at idle.  This was reported to help last, but unfortunately it looks like this was not committed.

Looks great! It now boots from internal storage and reports version b48cb18M-180725

Much appreciated :-)

This should use a little less power. Can you test and let me know if it works?

Both the 30 and the 26 work great - thanks!


[0] Message Index

[#] Next page

[*] Previous page

Go to full version