Support and General Use > Hardware

connecting sansa clip+ without USB.

<< < (2/2)

Bilgus:
well I think i'd try with linux a vm at the very least, and maybe you could pull the enable pin on the nand at the right time, ie after rb loads the bootloader but before it loads the firmware to get the bootloader to not enumerate the internal drive and go on to the sd card but even in theory the timing would be tight and its only a theory, but hey what do you have to lose??? you might even set up a microcontroller or a 555 time with a small delay so it is adjustable + repeatable other than that IDK maybe resolder the usb? I wish the OF had renaming capabilities then we could load a file with the microphone or something

heinkel:

--- Quote from: Bilgus on August 31, 2017, 06:42:13 PM ---well I think i'd try with linux a vm at the very least, and maybe you could pull the enable pin on the nand at the right time, ie after rb loads the bootloader but before it loads the firmware to get the bootloader to not enumerate the internal drive and go on to the sd card but even in theory the timing would be tight and its only a theory, but hey what do you have to lose??? you might even set up a microcontroller or a 555 time with a small delay so it is adjustable + repeatable other than that IDK maybe resolder the usb? I wish the OF had renaming capabilities then we could load a file with the microphone or something

--- End quote ---

I will try to figure out NAND pinout and solder to micro sd card reader. Stock firmware on this player is just awful. Can't support 32GB, poor battery life... :\

Navigation

[0] Message Index

[*] Previous page