Support and General Use > Hardware

connecting sansa clip+ without USB.

(1/2) > >>

heinkel:
Hello,
how to connect sansa clip+ without usb connection to PC, because USB won't work. I had this problem for long, but i formatted the whole player and rockbox is gone, expected that this would fix usb problem. What I want is some schematics for soldering if possible to the memory chip, something like JTAG. If there is any.
Thank you

saratoga:
If you formatted, the USB bootloader mode should still work.  I think you hold the center button when booting to use it.

It might be possible to use JTAG, but no one has looked into that.

heinkel:

--- Quote from: saratoga on August 31, 2017, 01:12:37 PM ---If you formatted, the USB bootloader mode should still work.  I think you hold the center button when booting to use it.

It might be possible to use JTAG, but no one has looked into that.

--- End quote ---

Sansa's clip+ usb is just messed up. Computer won't recognise, and afterwards it doesn't apper in device mangar like it's gone. But charges fine.

When booting with USB connected the sansa displays "bootloader USB mode". I can't connect to pc with stock firmware. I had this problem before, i just used my micro sd adapater to transfer files. This problem was not important until I formatted it. :\

I get this error: "Windows has stopped this device because it has reported problems. (Code 43)"

saratoga:
Try a different computer and see if you can get it to work there.  As far as I know there is no way to fix the device without USB.

heinkel:

--- Quote from: saratoga on August 31, 2017, 05:54:11 PM ---Try a different computer and see if you can get it to work there.  As far as I know there is no way to fix the device without USB.

--- End quote ---

Windows 7, sometimes connects gives error 43
XP, connects with stock (shows connected animation) and bootdevice, but not recognized (no drivers error)
Mac, nothing just charging.

Probably I'm screwed :D.

Navigation

[0] Message Index

[#] Next page