Support and General Use > Hardware

256GB SDXC in various Sansas - fails on Clip+

<< < (3/7) > >>

Doghouse Riley:
No joy.  ATA -4 on every boot with the card in place.  It does read the card when inserted after bootup.

Thanks very much for your effort.

(EDIT - It just did boot correctly a couple of times.  Let me try this build tonight on another Clip+ I have at home before jumping to conclusions.)

Mihail Zenkov:
Another build: http://knk.square7.ch/rockbox-clipplus_sd256_1.zip

Doghouse Riley:
Still not there.   Both the sd256_0 and _1 builds alternate between the following when booting with the card in place

displaying an ATA error with the Rockbox logo below
displaying an ATA error with nothing else
displaying a black screen, requires holding power button for ~60 seconds to get a reboot
booting up correctly with card recognized  :D

Thanks again for the response.  Perhaps we'll have to wait until these cards get cheaper and are in the hands of you and the other developers?

Mihail Zenkov:
Which exactly ata error you have with sd256_1 build? Or it just freeze?

Doghouse Riley:
Mihail,

From a clean install of the 256_1 build, and twenty attempts to boot with the 256g card in place:

Twelve attempts gave successful boots.

Eight attempts gave a black screen with no message of any kind.  These failed boots could only be recovered from by removing the card and pressing/holding the power button two or three times.  Leaving the card in place with the black screen still showing made a reboot impossible, even when holding the power button for up to five minutes.

Navigation

[0] Message Index

[#] Next page

[*] Previous page