Author Topic: ATA error: -2 at boot after updating Sansa Clip+ (dev builds) (Read 14412 times)

Mihail Zenkov · « **Reply #75 on:** August 13, 2017, 03:54:51 AM »

http://knk.square7.ch/rockbox-fuzev2_30.7z

cerb · « **Reply #76 on:** August 13, 2017, 03:58:33 AM »

Quote from: Mihail Zenkov on August 13, 2017, 03:54:51 AM

http://knk.square7.ch/rockbox-fuzev2_30.7z

That one works. Thanks!

Mihail Zenkov · « **Reply #77 on:** August 13, 2017, 04:04:17 AM »

Which exactly variant of Fuze v2 you have (system > debug > view hw info)?

cerb · « **Reply #78 on:** August 13, 2017, 04:05:57 AM »

AMSv2 variant 0

Mihail Zenkov · « **Reply #79 on:** August 13, 2017, 04:07:50 AM »

OK. Thanks for report!

saratoga · « **Reply #80 on:** August 13, 2017, 03:41:36 PM »

Thanks for looking at this, I have been away from my computer. What did you change to fix the problem? CVDD2?

Mihail Zenkov · « **Reply #81 on:** August 13, 2017, 04:25:39 PM »

I rise CVDD1 at low frequency. I not sure why sd controller (or nand) depend on CVDD1.

We have to many #ifdef for CVDD1 so I want define it in firmware/export/config/sansaclipplus.h and for other AMSv2. I'll post a patch for review in gerrit later.

Author Topic: ATA error: -2 at boot after updating Sansa Clip+ (dev builds) (Read 14412 times)

Mihail Zenkov

Re: ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

cerb

Re: ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

Mihail Zenkov

Re: ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

cerb

Re: ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

Mihail Zenkov

Re: ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

saratoga

Re: ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

Mihail Zenkov

Re: ATA error: -2 at boot after updating Sansa Clip+ (dev builds)