Support and General Use > Hardware
ATA error: -2 at boot after updating Sansa Clip+ (dev builds)
saratoga:
--- Quote from: Mihail Zenkov on June 09, 2017, 10:47:08 AM ---
--- Quote from: chilko on June 09, 2017, 05:16:10 AM ---I just faced the same problem when updating my Sansa+ from 3.13 to 3.14. Restored the older build and now everything is OK but is there a way to fix this as I want to use the new features and improvements?
--- End quote ---
Try this build: http://web.mit.edu/mgg6/www/rockbox-clip+-275v.7z
--- End quote ---
I committed that patch today since it helped some people.
Mihail Zenkov:
Good. I still don't have time to finish my work for CVDD2 scaling :(
cerb:
Hi, I'm getting the same ATA error -2 on a Fuze v2, both with v3.14 and the latest dev build. Reverting to v3.13 fixes the problem.
If I'm reading the wiki correctly, Fuze v2 and Clip+ have the same SoC, so perhaps the same changes are needed?
Mihail Zenkov:
--- Quote from: cerb on August 09, 2017, 02:16:15 PM ---Hi, I'm getting the same ATA error -2 on a Fuze v2, both with v3.14 and the latest dev build. Reverting to v3.13 fixes the problem.
If I'm reading the wiki correctly, Fuze v2 and Clip+ have the same SoC, so perhaps the same changes are needed?
--- End quote ---
Try this build: http://knk.square7.ch/rockbox-fuzev2_26.7z
cerb:
--- Quote from: Mihail Zenkov on August 12, 2017, 06:19:06 PM ---
--- Quote from: cerb on August 09, 2017, 02:16:15 PM ---Hi, I'm getting the same ATA error -2 on a Fuze v2, both with v3.14 and the latest dev build. Reverting to v3.13 fixes the problem.
If I'm reading the wiki correctly, Fuze v2 and Clip+ have the same SoC, so perhaps the same changes are needed?
--- End quote ---
Try this build: http://knk.square7.ch/rockbox-fuzev2_26.7z
--- End quote ---
I'm still getting ATA error -2 with that build
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version