ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

[chilko]

Same results.
I'm replacing .rockbox folder with the new one - am I doing this right? After that Sansa shows the error and is not recognized by the computer anymore. I need to shut it down by holding power button and then boot the original firmware to show in Explorer and revert to v3.13.

[Mihail Zenkov]

Is build from saratoga post (http://web.mit.edu/mgg6/www/rockbox-fef736be4ab1c2df33d15715badd6b5ff04c2285.7z) work?

[chilko]

Yes, that version works.

[Mihail Zenkov]

http://knk.square7.ch/rockbox-clipplus_v0_28.7z

[chilko]

This again leads to ATA error 2 on startup.

[Mihail Zenkov]

http://knk.square7.ch/rockbox-clipplus_v0_30.7z

[chilko]

This works.

[Mihail Zenkov]

Good. Last test build: http://knk.square7.ch/rockbox-clipplus_v0_29.7z

[chilko]

Works. Few seconds after startup there was kernel panic but after restart everything seems to be fine.

[Mihail Zenkov]

Ok. It is not completely stable. So switch to previous build (http://knk.square7.ch/rockbox-clipplus_v0_30.7z) and check it for few days. If it stable, I'll commit this changes.

[saratoga]

I just faced the same problem when updating my Sansa+ from 3.13 to 3.14. Restored the older build and now everything is OK but is there a way to fix this as I want to use the new features and improvements?

Try this build: http://web.mit.edu/mgg6/www/rockbox-clip+-275v.7z

I committed that patch today since it helped some people.

[Mihail Zenkov]

Good. I still don't have time to finish my work for CVDD2 scaling

[cerb]

Hi, I'm getting the same ATA error -2 on a Fuze v2, both with v3.14 and the latest dev build. Reverting to v3.13 fixes the problem.
If I'm reading the wiki correctly, Fuze v2 and Clip+ have the same SoC, so perhaps the same changes are needed?

[Mihail Zenkov]

Hi, I'm getting the same ATA error -2 on a Fuze v2, both with v3.14 and the latest dev build. Reverting to v3.13 fixes the problem.
If I'm reading the wiki correctly, Fuze v2 and Clip+ have the same SoC, so perhaps the same changes are needed?

Try this build: http://knk.square7.ch/rockbox-fuzev2_26.7z

[cerb]

Hi, I'm getting the same ATA error -2 on a Fuze v2, both with v3.14 and the latest dev build. Reverting to v3.13 fixes the problem.
If I'm reading the wiki correctly, Fuze v2 and Clip+ have the same SoC, so perhaps the same changes are needed?

Try this build: http://knk.square7.ch/rockbox-fuzev2_26.7z

I'm still getting ATA error -2 with that build