Support and General Use > Hardware

ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

<< < (14/17) > >>

Mihail Zenkov:
http://knk.square7.ch/rockbox-clipplus_v0_30.7z

chilko:
This works.

Mihail Zenkov:
Good. Last test build: http://knk.square7.ch/rockbox-clipplus_v0_29.7z

chilko:
Works. Few seconds after startup there was kernel panic but after restart everything seems to be fine.

Mihail Zenkov:
Ok. It is not completely stable. So switch to previous build (http://knk.square7.ch/rockbox-clipplus_v0_30.7z) and check it for few days. If it stable, I'll commit this changes.

Navigation

[0] Message Index

[#] Next page

[*] Previous page