Support and General Use > Hardware

ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

<< < (13/17) > >>

chilko:
Same results.
I'm replacing .rockbox folder with the new one - am I doing this right? After that Sansa shows the error and is not recognized by the computer anymore. I need to shut it down by holding power button and then boot the original firmware to show in Explorer and revert to v3.13.

Mihail Zenkov:
Is build from saratoga post (http://web.mit.edu/mgg6/www/rockbox-fef736be4ab1c2df33d15715badd6b5ff04c2285.7z) work?

chilko:
Yes, that version works.

Mihail Zenkov:
http://knk.square7.ch/rockbox-clipplus_v0_28.7z

chilko:
This again leads to ATA error 2 on startup.

Navigation

[0] Message Index

[#] Next page

[*] Previous page