Support and General Use > Hardware

ATA error: -2 at boot after updating Sansa Clip+ (dev builds)

<< < (2/17) > >>

qorx:
saratoga, the last one that works in my Clip+ is: c90d42d-160408
johnb, thanks for the build upload, unfortunately the same error is shown with that build too.

saratoga:
The only substantial change between those builds is that we enabled voltage scaling, so here is the current git but with voltage scaling disabled:

http://mit.edu/mgg6/www/rockbox-c7a561e-noVoltage-clip+.7z

qorx:
That one runs fine, thanks for compiling it. So it must be something with voltage scaling in my player.
How can I help debug?

Mihail Zenkov:
saratoga: I think we should try slightly rise (48 - 50) CVDD1 at boost. If it help we can add special case for clip+ as we already have for clip zip at normal freq.

saratoga:
Here is a build with voltage scaling enabled but a slightly higher boost voltage:

http://mit.edu/mgg6/www/rockbox-clipplus-49-voltage.7z

Navigation

[0] Message Index

[#] Next page

[*] Previous page