Support and General Use > Hardware
ATA error: -2 at boot after updating Sansa Clip+ (dev builds)
saratoga:
--- Quote from: Bitstream on July 25, 2016, 12:04:19 PM ---I did that too in the meantime (been trying for 2 hours), the drive sooner or later always disappears during any operation. No matter if Checkdisk or trying to delete anything.
--- End quote ---
Does the Sandisk firmware's reformat option work?
--- Quote from: Bitstream on July 25, 2016, 12:04:19 PM ---MUSIC folder is corrupted, Rockbox folder is not. But trying to delete it (I'll just try anything now) I get an error about the files not being accessible.
Using the Utility I also get an error (with or without also installing bootloader) about drive not being writable, this seems to be the relevant part:
--- End quote ---
If you can't access the disk there is no point in trying to copy over files with rockbox utility.
Bitstream:
--- Quote from: saratoga on July 25, 2016, 01:39:28 PM ---
--- Quote from: Bitstream on July 25, 2016, 12:04:19 PM ---I did that too in the meantime (been trying for 2 hours), the drive sooner or later always disappears during any operation. No matter if Checkdisk or trying to delete anything.
--- End quote ---
Does the Sandisk firmware's reformat option work?
--- End quote ---
As stated above, I haven't been able to get into the Sandisk firmware since 2014, it always hung at "Refreshing your media", and still is. Booting Rockbox now says "File Not found..." and then "Plug USB cable". Which I've been doing all day. ;)
The reformat, can it also be triggered by button combinations?
--- Quote ---
--- Quote from: Bitstream on July 25, 2016, 12:04:19 PM ---MUSIC folder is corrupted, Rockbox folder is not. But trying to delete it (I'll just try anything now) I get an error about the files not being accessible.
Using the Utility I also get an error (with or without also installing bootloader) about drive not being writable, this seems to be the relevant part:
--- End quote ---
If you can't access the disk there is no point in trying to copy over files with rockbox utility.
--- End quote ---
The drive sometimes looks normal for short periods of time (appears with correct name and capacity in explorer and can be accessed), so I was trying to get it done during one of those, but it never lasted long enough. Most of the time, I see no drive name, no capacity... I'm no expert at all, but considering that USB access has been very slow for me for years, I'd guess something is wrong with the hardware?
qorx:
Bitstream, sorry to hear you're running into issues.
Mihail, so far my player is working fine with build 25_116, I had only one time the ata error but I can see a pattern now and hope it helps in any way:
If I use it frequently I don't have any errors, however, if I let it sit for a day and then power it on, the ata error may appear. (it happened once so far)
Mihail Zenkov:
Ok, try this: http://knk.square7.ch/rockbox-clip_plus_26_116.zip
qorx:
--- Quote from: Mihail Zenkov on July 26, 2016, 12:20:06 PM ---Ok, try this: http://knk.square7.ch/rockbox-clip_plus_26_116.zip
--- End quote ---
Installed and ready to go testing.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version