Support and General Use > Hardware
ATA error: -2 at boot after updating Sansa Clip+ (dev builds)
Mihail Zenkov:
Ok, try this: http://knk.square7.ch/rockbox-clipplus_25_115.zip
qorx:
Thanks, will test and report back.
Djudge_Katt:
I'll be following this :)
I've run in to the exact same problem :P
I'm not much of a tester though; I wouldn't be knowing what I was doing xD
But know.. That you will have helped me too :D
qorx:
Mihail, since the day you posted the build to today, I had only 2 occurrences of the ata error -2 at boot, one was the first time I installed your build and the second yesterday, but with both it was just a matter of resetting and boot again without problems, so it's more stable for sure.
Djudge_Katt, good to know I'm not the only one running into this issue. Thanks for reporting it.
Mihail Zenkov:
Good, new build for test: http://knk.square7.ch/rockbox-clip_plus_25_116.zip
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version