Support and General Use > Hardware
ATA error: -2 at boot after updating Sansa Clip+ (dev builds)
saratoga:
Let me know if 23 has any problems, I will commit if it's OK.
Could just be a little weaker flash memory chip.
qorx:
I put my settings back on and got a panic, I'll have to check if it's the EQ...
saratoga:
That was with 23?
qorx:
Yes it was.
saratoga:
Sounds like 24 might be needed then. I just want to be careful since this will decrease everyone's battery life by a little bit, but if devices are occasionally crashing, it should be fixed.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version