Support and General Use > Hardware
ATA error: -2 at boot after updating Sansa Clip+ (dev builds)
qorx:
Hi,
I'm unable to update my Clip+ from several builds back.
After updating either manually or with rbutil, an ATA error: -2 is shown in rolo. Latest builds all give same error so I reverted to the one I had as backup: c90d42d-160408 which runs fine.
This happens even with all default settings set.
Formatted, checked for file system errors and reinstalled everything again but nothing seems to get past the boot error unless reverting..
If I update to the latest build and replace "Rockbox.sansa" file with the one from my backup, it starts normally, no error shown.
saratoga said in irc that I'm the first to report this error, so as he suggested here's the forum topic.
saratoga:
I believe ATA error -2 just means that the storage couldn't be read. This is likely due to the recent changes to voltage and frequency scaling.
What was the oldest build you tried that did not work?
qorx:
All builds from here: http://www.rockbox.org/dl.cgi?bin=sansaclipplus did not work, so I gave up and installed my backup but it seems that it was around May because the one I have is from 160408 and I've another from 160414 that also runs fine.
If you can get me some builds prior to the ones in that page, I can test more if you want.
saratoga:
We don't have download links for old builds, they must be compiled. Post the build number for the last build that worked correctly.
johnb:
Hi,
here is the build that has all the voltage and frequency scaling (rockbox-sansaclipplus.18fecd9.zip 160422). All of my clip+es work fine with it.
https://app.box.com/s/tbii7up8i2btfgegqc3g624igv6yjx4n
Regards
johnb
Navigation
[0] Message Index
[#] Next page
Go to full version