Support and General Use > Hardware

clip zip bricked?

<< < (4/5) > >>

fitz:

--- Quote from: Mihail Zenkov on April 28, 2016, 06:20:01 PM ---Just type 'dmesg' in terminal. You also can redirect output of command to file: dmesg > dmesg.txt

--- End quote ---


257.943020] usb 5-2: new high-speed USB device number 4 using ehci-pci
[  258.058915] usb 5-2: New USB device found, idVendor=0781, idProduct=74e5
[  258.058919] usb 5-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[  258.058922] usb 5-2: Product: Rockbox media player
[  258.058924] usb 5-2: Manufacturer: Rockbox.org
[  258.058926] usb 5-2: SerialNumber: 1A8C5009705F11F2E00000000
[  258.061708] usb-storage 5-2:1.0: USB Mass Storage device detected
[  258.061786] scsi8 : usb-storage 5-2:1.0
[  259.064557] scsi 8:0:0:0: Direct-Access     Rockbox  Internal Storage 0.00 PQ: 0 ANSI: 4
[  259.066676] sd 8:0:0:0: [sdd] 7683072 512-byte logical blocks: (3.93 GB/3.66 GiB)
[  259.067297] sd 8:0:0:0: [sdd] Write Protect is off
[  259.067300] sd 8:0:0:0: [sdd] Mode Sense: 0b 00 00 08
[  259.067918] sd 8:0:0:0: [sdd] No Caching mode page present
[  259.067920] sd 8:0:0:0: [sdd] Assuming drive cache: write through
[  259.070919] sd 8:0:0:0: [sdd] No Caching mode page present
[  259.070922] sd 8:0:0:0: [sdd] Assuming drive cache: write through
[  259.074174]  sdd:
[  259.077296] sd 8:0:0:0: [sdd] No Caching mode page present
[  259.077300] sd 8:0:0:0: [sdd] Assuming drive cache: write through
[  259.081420] sd 8:0:0:0: [sdd] Attached SCSI removable disk
[  291.846021] usb 5-2: reset high-speed USB device number 4 using ehci-pci
[  306.948028] usb 5-2: device descriptor read/64, error -110
[  322.151021] usb 5-2: device descriptor read/64, error -110
[  322.354020] usb 5-2: reset high-speed USB device number 4 using ehci-pci
[  337.456018] usb 5-2: device descriptor read/64, error -110
[  352.659021] usb 5-2: device descriptor read/64, error -110
[  352.862025] usb 5-2: reset high-speed USB device number 4 using ehci-pci
[  363.264019] usb 5-2: device not accepting address 4, error -110
[  363.366023] usb 5-2: reset high-speed USB device number 4 using ehci-pci
[  373.768498] usb 5-2: device not accepting address 4, error -110
[  373.768526] usb 5-2: USB disconnect, device number 4
[  373.768587] sd 8:0:0:0: Device offlined - not ready after error recovery
[  373.873023] usb 5-2: new high-speed USB device number 5 using ehci-pci

Mihail Zenkov:
You have same messages if you connect when rockbox loaded?

fitz:

--- Quote from: Mihail Zenkov on April 28, 2016, 06:39:44 PM ---You have same messages if you connect when rockbox loaded?

--- End quote ---

yes it's the same.

and here's with the original firmware

909.186026] usb 2-2: new high-speed USB device number 14 using ehci-pci
[  909.301436] usb 2-2: New USB device found, idVendor=0781, idProduct=74e5
[  909.301440] usb 2-2: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[  909.301443] usb 2-2: Product: Sansa Clip Zip
[  909.301445] usb 2-2: Manufacturer: SanDisk
[  909.301447] usb 2-2: SerialNumber: 2E1FF1059700C5A80000000000000000
[  909.308457] usb-storage 2-2:1.0: USB Mass Storage device detected
[  909.308534] scsi13 : usb-storage 2-2:1.0
[  910.310702] scsi 13:0:0:0: Direct-Access     SanDisk  Sansa Clip Zip 4 v01. PQ: 0 ANSI: 0
[  910.312325] sd 13:0:0:0: [sdd] 7683072 512-byte logical blocks: (3.93 GB/3.66 GiB)
[  910.312701] scsi 13:0:0:1: Direct-Access     SanDisk  Sansa Clip Zip 4 v01. PQ: 0 ANSI: 0
[  910.313757] sd 13:0:0:0: [sdd] Write Protect is off
[  910.313761] sd 13:0:0:0: [sdd] Mode Sense: 04 00 00 00
[  910.314706] sd 13:0:0:0: [sdd] No Caching mode page present
[  910.314709] sd 13:0:0:0: [sdd] Assuming drive cache: write through
[  910.315087] sd 13:0:0:1: [sde] 61405184 512-byte logical blocks: (31.4 GB/29.2 GiB)
[  910.316814] sd 13:0:0:1: [sde] Write Protect is off
[  910.316818] sd 13:0:0:1: [sde] Mode Sense: 04 00 00 00
[  910.317688] sd 13:0:0:1: [sde] No Caching mode page present
[  910.317691] sd 13:0:0:1: [sde] Assuming drive cache: write through
[  910.322066] sd 13:0:0:0: [sdd] No Caching mode page present
[  910.322069] sd 13:0:0:0: [sdd] Assuming drive cache: write through
[  910.327195]  sdd:
[  910.327813] sd 13:0:0:1: [sde] No Caching mode page present
[  910.327816] sd 13:0:0:1: [sde] Assuming drive cache: write through
[  910.331319]  sde: sde1
[  910.335438] sd 13:0:0:0: [sdd] No Caching mode page present
[  910.335442] sd 13:0:0:0: [sdd] Assuming drive cache: write through
[  910.336085] sd 13:0:0:1: [sde] No Caching mode page present
[  910.336087] sd 13:0:0:1: [sde] Assuming drive cache: write through
[  910.337065] sd 13:0:0:0: [sdd] Attached SCSI removable disk
[  910.338439] sd 13:0:0:1: [sde] Attached SCSI removable disk

Mihail Zenkov:
Are you have some errors in dmesg after running fsck with original firmware?

fitz:

--- Quote from: Mihail Zenkov on April 28, 2016, 07:20:25 PM ---Are you have some errors in dmesg after running fsck with original firmware?

--- End quote ---


no there's no error message

Navigation

[0] Message Index

[#] Next page

[*] Previous page