Support and General Use > Hardware

[Sansa Clip v2] Loading firmware. File not found

(1/2) > >>

Graham1:
If I charge my Sansa whilst it is switched off, I get the following error:-

"Loading firmware. File not found" and then displays "Bootloader USB mode".

If I unplug at this stage, I then get this error:-

"*PANIC* Unhandled masked IRQ 03: INT_USB (status 0x00000008)"

If the Sansa is switched on before charging, it seems to charge ok (displays usb logo)

I am running version fe9a3ceM-160327.

:)

saratoga:
The USB crash will probably be fixed in a few days once the i2c rework goes in.  Or at least I suspect it will be much less likely.

No idea about the "file not found" thing in the title. 

Graham1:

--- Quote from: saratoga on April 04, 2016, 07:14:58 PM ---The USB crash will probably be fixed in a few days once the i2c rework goes in.  Or at least I suspect it will be much less likely.

No idea about the "file not found" thing in the title.
--- End quote ---

Confirmation that the above is fixed with build 98c15fe-160405. Thanks.

:)

Mihail Zenkov:
Good :)

Graham1:

--- Quote from: Graham1 on April 04, 2016, 06:41:46 PM ---If I charge my Sansa whilst it is switched off, I get the following error:-

"Loading firmware. File not found" and then displays "Bootloader USB mode".

If the Sansa is switched on before charging, it seems to charge ok (displays usb logo)
--- End quote ---

This above message has re-occurred with build 6548dc2-160414. Whilst the Sansa is displaying "Bootloader USB mode", it does not charge in this state.

:)

Navigation

[0] Message Index

[#] Next page