Support and General Use > Hardware
[Sansa Clip v2] - Blank Display [RESOLVED]
saratoga:
Ok so its probably not my recent frequency scaling changes. I'm not sure then, have you tried any builds since 3.13 but before this month? A lot has changed over the last few years.
Graham1:
--- Quote from: saratoga on March 04, 2016, 11:35:50 AM ---Ok so its probably not my recent frequency scaling changes. I'm not sure then, have you tried any builds since 3.13 but before this month? A lot has changed over the last few years.
--- End quote ---
No, I haven't tried any of the previous builds. I have been using the Rockbox utility to pull down the stable and development versions. Is it just a case of unzipping these builds and then copy/paste onto the root of the clip? (deleting the previous version first).
I'll test a few and report back which is the latest working version.
:)
EDIT: I have tested the latest builds of each Rev (2016-02-16, 12, 7 and 6) and all show a blank screen.
saratoga:
Unfortunately we don't provide binaries for old development builds so you would have to compile them yourself. I was hoping you had tried some builds in the past and could give some clues.
Graham1:
--- Quote from: saratoga on March 04, 2016, 01:00:24 PM ---Unfortunately we don't provide binaries for old development builds so you would have to compile them yourself. I was hoping you had tried some builds in the past and could give some clues.
--- End quote ---
Sorry, I only joined the other day :). Not to worry, I'll put the stable version back on. Thanks for all your help. Appreciated.
:)
zeon:
--- Quote from: Graham1 on March 03, 2016, 05:16:12 PM ---Installing the development version (5138995) on my sansa clip v2 displays a blank screen straight after applying the firmware.
--- End quote ---
Me too. This happens with 5138995 build only.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version