Support and General Use > Hardware
[Sansa Clip v2] - Blank Display [RESOLVED]
C0da:
I have the same problem wist the broken screen. Tried all files without success.
Can someone walk me through the music folder to play at least the songs without the screen? Which buttons do I have to press?
Graham1:
Also, once the display is working but then times out (backlight off), the same problem with the blank screen which can only be resolved by sliding down and up again.
:)
Mihail Zenkov:
--- Quote from: Graham1 on March 25, 2016, 04:15:17 PM ---Blank after boot. Not sure if you were joking about hold and power buttons being disabled but both are working. Pressing hold and sliding up again shows display each time. Interface navigation is very sluggish.
--- End quote ---
Very strange.
saratoga: Can you test hold and power button on your clip v2 with this (http://knk.square7.ch/rockbox-1.zip) build?
--- Quote from: C0da on March 25, 2016, 04:21:15 PM ---I have the same problem wist the broken screen. Tried all files without success.
Can someone walk me through the music folder to play at least the songs without the screen? Which buttons do I have to press?
--- End quote ---
Probably better revert rockbox to version 3.13.
saratoga:
--- Quote from: Mihail Zenkov on March 25, 2016, 05:21:30 PM ---saratoga: Can you test hold and power button on your clip v2 with this (http://knk.square7.ch/rockbox-1.zip) build?
--- End quote ---
Power button is completely disabled, but the hold switch works. Otherwise the build is completely normal on my device.
Graham1:
--- Quote from: C0da on March 25, 2016, 04:21:15 PM ---I have the same problem wist the broken screen. Tried all files without success.
Can someone walk me through the music folder to play at least the songs without the screen? Which buttons do I have to press?
--- End quote ---
Hi C0da
Does sliding down (hold) and up again work on your Sansa Clip v2?
:)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version