Support and General Use > Hardware

[Sansa Clip v2] - Blank Display [RESOLVED]

<< < (7/15) > >>

Graham1:

--- Quote from: saratoga on March 23, 2016, 03:43:12 PM ---http://web.mit.edu/mgg6/www/rockbox-clipv2-button_hold.7z

Let us know if this works any better.
--- End quote ---

Blank screen after logo. No display after keypress now.

:)

Mihail Zenkov:
Another build for test: http://knk.square7.ch/rockbox-0.zip

Graham1:

--- Quote from: Mihail Zenkov on March 24, 2016, 03:54:14 AM ---Another build for test: http://knk.square7.ch/rockbox-0.zip
--- End quote ---

Still a blank display.

:)

Mihail Zenkov:
Ok ;) I disable hold and power button to be sure that not related.
http://knk.square7.ch/rockbox-1.zip

Graham1:

--- Quote from: Mihail Zenkov on March 25, 2016, 05:42:43 AM ---Ok ;) I disable hold and power button to be sure that not related.
http://knk.square7.ch/rockbox-1.zip
--- End quote ---

Blank after boot. Not sure if you were joking about hold and power buttons being disabled but both are working. Pressing hold and sliding up again shows display each time. Interface navigation is very sluggish.

Edit: Straight after boot, sliding down (hold) and back up again displays screen instantly.

Edit2: The same above applies to the latest development build and navigation is still sluggish.

:)

Navigation

[0] Message Index

[#] Next page

[*] Previous page