Support and General Use > Hardware

[Sansa Clip v2] - Blank Display [RESOLVED]

<< < (5/15) > >>

Graham1:
Occasionally, the screen displays after pressing a button but doesn't display instantly like 3.13 did. It's a bit trial and error but usually the longer you leave the clip without pressing a button, the more chance you have of the screen appearing. If you press a button and the screen doesn't display, it doesn't after that.

:)

saratoga:
Here are two longer delays.  Do either of them work?

http://www.web.mit.edu/mgg6/www/rockbox-clipv2-lcddelay_50.7z
http://www.web.mit.edu/mgg6/www/rockbox-clipv2-lcddelay_100.7z

Graham1:

--- Quote from: saratoga on March 18, 2016, 11:36:19 AM ---Here are two longer delays.  Do either of them work?
http://www.web.mit.edu/mgg6/www/rockbox-clipv2-lcddelay_50.7z
http://www.web.mit.edu/mgg6/www/rockbox-clipv2-lcddelay_100.7z
--- End quote ---

Blank display on both. Could you confirm I'm applying the correct actions.

1. Use Rockbox Utility 1.4.0 to install boot loader only (development version). Boots as 5.0
2. Extract zip and copy ".rockbox" folder to root of Sansa Clip v2.
3. Waited 50 and 100 secs after each installation.

Pressing the play button after these times did display menu on both these installations.

:)

saratoga:
You don't need rockbox utility, just to copy the build to the player.  Is that what you were doing?

Mihail Zenkov:
saratoga: I am very unsure is it related, but can you also add big delay in button_hold (as it was for fuze v2)?

Navigation

[0] Message Index

[#] Next page

[*] Previous page