Support and General Use > Hardware

[Sansa Clip v2] - Blank Display [RESOLVED]

(1/15) > >>

Graham1:
Hi

Installing the development version (5138995) on my sansa clip v2 displays a blank screen straight after applying the firmware. Rockbox seems to be running in the background as the clip lights up when buttons are pressed and occasionally the screen re-appears. I'll edit this post again if I can confirm which buttons worked. Btw, the stable release (version 3.13) works without any problems.

:)

saratoga:
Can you post your config.cfg file contents?

Graham1:

--- Quote from: saratoga on March 03, 2016, 05:57:50 PM ---Can you post your config.cfg file contents?
--- End quote ---

Hi saratoga

Please see my config.cfg below

:)


# .cfg file created by rockbox 5138995-160216 - http://www.rockbox.org

volume: -24
selector type: pointer
scrollbar width: 5
time format: 12hour
sbs: /.rockbox/wps/classic_statusbar.sbs

saratoga:
Try this build:

www.mit.edu/mgg6/www/rockbox-clipv2_noscaling.7z

Graham1:

--- Quote from: saratoga on March 03, 2016, 07:46:03 PM ---Try this build:

www.mit.edu/mgg6/www/rockbox-clipv2_noscaling.7z
--- End quote ---

Same blank screen I'm afraid :'(.

When I switch on the clip, the rockbox logo appears briefly and then the screen goes blank. Shortly after this, the arrow keys and circle light up blue and then turn off after a couple of seconds.

:)

EDIT: Btw, booting into Sandisk's firmware (left arrow + power) loads fine.

Navigation

[0] Message Index

[#] Next page